PF100 Pellet Furnace

The Harman PF100 Hot Air Pellet Furnace takes pellet fuel heating to its optimum level, operating automatically to give you warm, comfortable temperatures throughout your home. Simply fill the hopper with pellets and set the temperature dial on the wall mounted control to the desired setting. The PF100 will do the rest. If heat is required, the fire will automatically light and burn at the proper rate to produce just the right amount of heat. If heating demand is reduced, the Harman PF100 will reduce the fire. If no heat is required, the fire will go out and light again automatically if more heat is needed.

When the fuel in the hopper gets low, the red light on the wall control will blink, telling you to add fuel to the hopper.

The PF100’s huge ash pan allows two to three tons of pellets to be burned before emptying.

With the patented Harman feeder and burn pot, even high ash pellets can be burned efficiently.

The PF100 can be installed as a stand-alone hot air heating system or incorporated into existing hot air systems. A chimney is not required for venting. This direct vent system can also use outside air for combustion.

Dual heat exchangers are used to extract maximum heat from the fuel, which will save you money.


  • Automatic Ignition
  • Total Automatic Operation
  • Patented Pellet Pro Feeder
  • Patented Pellet Pro Burn Pot
  • Dual Heat Exchangers
  • Large Ash Door
  • Extra Large Ash Pan
  • Fire Viewing Glass
  • 3 Speed Blower
  • Direct Vent
  • Easy Cleaning
  • Wall Mounted Control


  • Outside Air
  • 1500 cfm 2 Speed Blower
  • 2000 cfm 3 Speed Blower

Optimum Performance Level
The frequency of ash removal is greatly reduced due to the extra large ash pan. The combustion blower design eliminates the need for a chimney and can be easily removed for annual cleaning. A shaker handle is used to clean the heat exchanger tubes. This is easy to do and is normally done when hopper is filled. The wall mounted temperature control allows you to set your desired temperature. The PF100 will do the rest.



Fuel: Bio-Mass Pellets
BTU Range: 0 to 112,000
Heating Capacity: 2,500 Square Feet
Hopper Capacity: 160 lbs
Blower Size: 1000 cfm
Flue Size: 4 inches Pellet Vent Pipe
Outside Air Size: 2.75 inches
Fuse Rating: 10 amp circuit breaker
Weight: 450 lbs
Depth: 62.44 inches
Height: 49.65 inches
Width: 26 inches
Feed Rate: 1 to13 lbs per hour
Venting Size: 4 inches Pellet Vent Pipe
Testing: Tested to: CAN/CSA B366.10-M91, UL 391, ASTME 1509-95, ULC C1482-M1990


Clearances & Dimensions

Rear: 1 inch
Side: 12 inches
Front: 1 inch

@ Kegerreis Stoves.